Insert batteries
Open the cap on the right side and insert 3x standard AA batteries. You can also use rechargeable batteries if you prefer.
Power-up the device
When setting it up for the first time, and everytime it is not able to connect to an existing WiFi network, the device will start in “access-point/captive-portal" mode and it will broadcast the WiFi SSID “CryptoGadgets”.
Connect your phone
Connect your phone/computer to the “CryptoGadgets” WiFi network using the following password: 12345678
Access the setup interface
Your phone/computer should prompt you with a login/welcome page. If not you can simply browse to the following address: http://172.217.28.1. You should then be able to see and access the device setup interface.
Browse the available networks
On the menu click “Configure WiFi”. You should then be presented with a list of existing WiFi networks.
Connect the device to your WiFi
Click on your network SSID name, enter your passphrase and click “Apply”.
Pair the device with your Telegram account
The device should now display a QR code. Use your phone to scan the QR code, tap the banner that appears on your phone and click "START" on Telegram.
If in the future you want to pair the device to a different Telegram account, just keep the button-1 pressed until a new QR code is generated.
Use Telegram to change settings
Now that your device is paired you can easily use Telegram to configure your device settings.
Just navigate through the menu to change operating mode, time-zone, refresh interval, etc.
